BMW I7 SEDAN
Is your VIN affected?
All Recalls
0 campaignsNo recalls match your filters.
›Owner complaints (15)
[XXX] Problem: Multiple tire blowouts causing safety hazards and air-suspension damage Complaint Summary: My 2024 BMW i7 has experienced multiple tire blowouts, including the most recent , two within days of each other (12/8/2025 and 12/10/2025). On 12/8/2025, BMW replaced the right rear tire and advised me that the vehicle was safe to drive. Two days later, the left rear tire suffered the same sudden failure, requiring another tow. These failures occurred during normal driving and immediately after BMW dealership inspection and clearance. In addition to these recent events, earlier blowouts on this vehicle have already caused damage to the air-suspension system, requiring repairs. This indicates the issue is not normal tire wear but a recurring safety defect involving the vehicle’s weight, load distribution, tire load rating, or compatibility with the i7’s unusually high curb weight. The repeated failures and resulting suspension damage raise concerns about a broader defect in the design, load-bearing capability, or inspection procedures for this model. This vehicle is unsafe to operate, and the recurring blowouts place my family and other motorists at risk. I am requesting that NHTSA investigate whether the BMW i7 has a systemic safety issue related to tire integrity, load capacity, or suspension stress under normal driving conditions. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
On November 9, 2024 while driving the vehicle in light traffic on the 405 southbound between the 101 and the 10 freeways, the right front of the vehicle made a cluck noise. There were no obsticales on the freeway and no other vehicle was involved. Shorthly thereafter, the vehicle made another loud clunk noise from the right front of the vehicle. I exited the 405 freeway and turned right. Within a mile, the right front suspension totally collapsed causing the car to careen left. On the street I was on, there is a center median with a curb. the car rode the curb for several feet and the left front end of the vehicles suspension collapsed. The car came to a halt and was towed to the BMW dealer where I leased the car. The car computer said chassis function restricted. Fortunately there were no other vehicles involved since the car was no longer drivable after the catastrophic suspensinon collapse. It should also be noted that for the first 3 months after leasing this vehicle, the computer did not recognize the keys or fobs (being locked out of the car consistently) and after numberous attempts to fix the matter, BMW had the vehicle for over 6 weeks. It is evident that the i7 EDrive 50 has serious safety issues that may be related to its computer system. These two issues should be looked at. Had the suspension collapsed on the freeway the car most likely would have been in a serious collision.
My knee has accidentally opened the driver door during travel which has caused the door to open unintentionally and brings the car to a stop in traffic.
The contact owns a 2024 BMW I7. The contact stated while driving approximately 45 MPH, the "Inability to Drive" message was displayed on the instrument panel and the vehicle suddenly lost motive power. The contact received notification of NHTSA Campaign Number: 24V104000 (Electronic Stability Control (ESC), Service Brakes, Hydraulic); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the failure. The failure mileage was approximately 7,500. VIN tool confirms parts not available.
The contact owns a 2024 BMW I7. The contact stated that the vehicle failed to respond when the brake pedal was depressed. The contact stated that the brakes were occasionally inoperable. The contact had been driving 25 MPH due to concerns about the brakes failing with his children inside the vehicle. The contact received notification of NHTSA Campaign Number: 24V104000 (ELECTRONIC STABILITY CONTROL (ESC), SERVICE BRAKES, HYDRAULIC); however, the part to do the recall repair was not yet available. The local dealer was not contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The failure mileage was approximately 2,000. VIN tool confirms parts not available.
Yesterday again my 2024 I7 x50 bmw suddenly engaged its auto brakes. I have been in communication with different dealers trying to repair this problem as it almost cause another accident. Luckily there was no cars behind me and there was no cars ahead of me. The cars door also would not close. I have video evidence of this
This is the 4th time I am having issues with this car. Major safety issues. Yesterday during during on the 405 freeway. It suddenly started to rain, the wiper malfunction while in traffic and pouring rain. A week before this incident, the steering of the car kept moving suddenly out of my line. This time my son was in the car. These dealerships do not really care to even look at it, they drive the car for 2 miles and return it with a no problem found issue. Enough is Enough. The last time it was taking to the dealership after the automatic brakes would engage suddenly, they advise me that car was taken to a mechanic which is ridiculous. I am not in communication with BMW head quarters and they keep telling me to wait for a decision. This is not a waiting decision.
This is has been continuous, yesterday my car braked on the freeway. Suddenly with no obstruction. The car behind me almost crashed into me and it would’ve been a very tragic event. I took it to the dealership and they don’t do anything, all they do is give it back to me. Yesterday also has loss of power too. I have alerted them many times, they keep saying to take it in but they don’t do anything and I don’t feel with this car. Please let BMW know because if something happens they will be heard responsible
Complaints are self-reported to NHTSA by owners and are not verified by the agency.
›Full analysis: how to read the BMW I7 SEDAN recall historyYear range, common components, complaint patterns, and how to use this page.
Understanding the BMW I7 SEDAN recall history
The BMW I7 SEDAN currently has 0 recall campaigns and 15 owner complaints indexed from the NHTSA public database. Each recall represents a formal campaign to fix a defect at no cost to the current owner. Owner complaints are self-reported incidents that haven't (yet) resulted in a recall but can indicate emerging patterns worth watching.
NHTSA's complaint database for the I7 SEDAN records 1 crash report. Complaint data is unverified and shouldn't be read as a blanket condemnation of the model (large production volumes naturally produce more reports), but it is useful for spotting whether a specific defect has a serious real-world pattern behind it.
How to use this page
The safest path for an owner is to run your VIN through the checker above. A VIN query hits NHTSA's live API and tells you whether your specific I7 SEDAN has an open, unresolved recall. If you're researching a used I7 SEDANbefore buying, use the recall list below to understand the model's full history, then check the seller's VIN to see whether prior owners actually completed the free repairs. Many don't, and unresolved recalls can linger for years.
Figures are generated live from the RecallScanner dataset, which is sourced from NHTSA's public recall and complaint APIs and refreshed daily. RecallScanner is independent and not affiliated with BMW or any U.S. government agency.